Replacement Parts Information - Mendota DXV35 TIMBERFIRE Installation And Operating Instructions Manual

6.7 REPLACEMENT PARTS INFORMATION

How to Access Components
The descriptions below show where the main fireplaces components are located and how to access them for service. The
descriptions show how to access the components after the fireplace has been installed. All components are also accessible from
the outside of the unit before the fireplace is installed.
Pilot: The pilot light is located on the right side the firebox to the right ends of the burners.
Gas Valve: The main gas valve is located behind the lower grill and beneath the firebox.
Complete Valve Assembly: To make working on components easier, this fireplace has been designed with the valve, pilot,
shutter boxes, shutter cables and gas lines as part of one assembly that can be removed from the fireplace. To remove the
assembly, first remove burners and burner airbox. After disconnecting the gas line and wires, below the firebox, remove hex nuts
that secure the valve mounting plate to firebox floor. Lift up and remove the entire assembly from the firebox.
Convection Blowers: The convection blowers are mounted on the firebox's rear wall. To access the convection blowers, remove
the Valve Assembly first.
General Replacement Parts List
PART NO
TADPOLE GLASS GASKET (106")
65-02-00103
65-06-00463
DOOR FRAME ASSEMBLY – FLAT
HA-30-00415
35-01-00240
35-01-00239
35-01-00601
05-02-00313
HA-30-00470
85-03-01115
DESCRIPTION
GLASS – FLAT
COALS 12 OZ BAG
GLOWING INSWOOL
FIREBRICK KIT
SIT VALVE NAT. GAS
PILOT ASSY. LPG
DXV35 TIMBERFIRE
PART NO
05-04-00035 PILOT ASS'Y. NAT.GAS
HA-30-00237
65-14-00030 ORIFICE (NAT. GAS) # 30
65-14-00049 FRONT ORIFICE (NAT. GAS) # 49
15-02-00120 R H BLOWER WITH MOTOR
15-02-00121 L H BLOWER WITH MOTOR
65-06-00125 BLACK PAINT - 12 OZ. SPRAY CAN
65-06-00455 KEL-KEM GLASS CLEANER/POLISH
DESCRIPTION
LP KIT
Page 77