Mendota DXV35 TIMBERFIRE Installation And Operating Instructions Manual page 50

How to Remove Door
1. Place both thumbs on lower doorframe directly above Spring Loaded Door Holding Bar.
2. Reach fingers under Bar and pull Bar straight out from Fireplace front.
3. Pull Bar down and move Bar inward until Bar clears doorframe - then release.
4. Repeat procedure for opposite Holding Bar.
5. Carefully lift door straight up until doorframe "clears" the 3 Door Holding Tabs on top of firebox.
6. Pull door directly out from firebox front
Door is now free from unit.
NOTE: Always check glass
gasket condition and
gasket seal any time the
glass door is removed and
when reinstalling glass
door.
How To Replace Door
1. Center door in firebox
opening. Move door
inward until the 3
slots on doorframe
are directly above
2. the 3 Door Holding
Tabs on firebox top.
3. Lower door so the 3
Tabs on firebox top fit
through the 3 slots on the doorframe. (i.e. "Hang" door on the 3 Tabs)
4. "Swing in" the lower edge of door until it touches lower firebox front.
5. Pull Holding Bar down and outward (away from Fireplace) until it clears doorframe.
6. Raise Bar until it fits securely in Bar Holding Brackets on doorframe.
7. Repeat procedure for opposite Holding Bar.
Door is now connected and sealed to unit.
85-03-01115 DXV35 TIMBERFIRE
Figure 4-7 Door Operation
Page 50