Table of Contents
Advertisement
6.
On the Routing — Default Gateway page set the priority of WAN interfaces used as default
gateways then click Next
If multiple WAN interfaces are configured, you can define the priority by their position in the
Selected Default Gateway Interfaces window. Top is the highest priority; bottom the
lowest.
Change the priority order by removing all items from the Selected Default Gateway
Interfaces window by selecting them, then clicking the right arrow button. Select the items in
the priority order, then click the left arrow to move them into the Selected Default Gateway
Interfaces window.
7.
On the DNS Server Configuration page set the priority of WAN interfaces to be used as
DNS server interfaces then click Next
If multiple WAN interfaces are configured, you can define the priority by their position in the
Selected DNS Server Interfaces window. Top is the highest priority; bottom the lowest.
Change the priority order by removing all items from the Selected DNS Server Interfaces
window by selecting them, then clicking the right arrow button. Select the items in the priority
order, then click the left arrow to move them into the Selected DNS Server Interfaces
window.
For a Static DNS IP Address, enter a primary and secondary DNS server for your modem,
8.
On the WAN Setup – Summary page review your settings and click Apply/Save to accept
the settings. To change your settings, click the Back button on the WAN Setup – Summary
page (do not click the browser Back button).
In the Wide Area Network (WAN) Service Setup page, you will see the new WAN interface
added.
Add an IPoA WAN Service
1.
Add an IPoA Layer 2 interface as described above (Add a Layer 2 Interface).
2.
Under Advanced Setup click WAN Service then click Add.
3.
WAN Service Interface Configuration page, select the DSL link associated with the IPoA
interface from the drop down, then click Next
4.
On the WAN Service Configuration page, enter a name if you wish to customize the
description shown for the service, then click Next.
5.
On the WAN IP Settings page enter a WAN IP address and WAN subnet mask as
instructed by your ISP, then click Next.
6.
On the Network Address Translation Settings you will need to enter information provided
by your ISP, then click Next.
Enable KeepAlive: Enables/disables TCP keep alive packets.
KeepAlive Timer: When Enable KeepAlive is selected, this input box indicates how
often the device should send keep alive packets.
Max Fail: Number of times the router should re-attempt PPPoA authentication after a
failure.
Enable IGMP Multicast Proxy: Configures the router for IGMP snooping so the router
can keep limit multicast traffic.
65xx-A1 Family Router Users Guide
46
Hide quick links:
Advertisement
Table of Contents
