Add A Bridge Wan Service; Add A Pppoe Wan Service - Zhone 6519-X1 User Manual

1. In the left hand menu pane, click Advanced Setup.
2. Under Advanced Setup, click Layer2 Interface then ETH Interface, then click the Add
button.
3. Select an Ethernet port to use as a WAN interface.
4. Select a connection mode:
Default Mode: a single service over the one connection
VLAN MUX Mode: multiple VLAN services over the one connection
5. Click Apply/Save to add the appropriate WAN service.

Add a Bridge WAN Service

1. Add an EoA Layer 2 interface as described above (Add a Layer 2 Interface).
2. Under Advanced Setup click WAN Service then click Add.
3. On the WAN Service Interface Configuration page, select the DSL link associated with the
bridge interface from the drop down, then click Next.
4. On the WAN Service Configuration page, select Bridging.
5. On the WAN Service Configuration page, enter a name if you wish to customize the
description shown for the service, then click Next.
6. In the WAN Setup – Summary page, review the settings for this interface. Click Apply/Save
to accept the settings.
If you made a mistake on the configuration and want to make changes to it, select the
Remove check box and click the Remove button.
In the Wide Area Network (WAN) Service Setup page, you will see the new WAN interface
added.

Add a PPPoE WAN Service

1. Add an EoA Layer 2 interface as described above (Add a Layer 2 Interface).
2. Under Advanced Setup click WAN Service then click Add
3. On the WAN Service Interface Configuration page, select the DSL link associated with the
PPPOE interface from the drop down, then click Next
4. On the WAN Service Configuration page, select PPP over Ethernet (PPPoE).
5. On the WAN Service Configuration page, enter a name if you wish to customize the
description shown for the service, then click Next.
6. On the PPP Username and Password page you will need the following information:
PPP Username: Your account from ISP to access Internet.
65xx-A1 Family Router Users Guide
41