Table of Contents
Advertisement
Minimal Installation for Service
Providers
In the following procedures, once the unit is installed and minimal configuration is completed
using the Easy Install feature, the NOC can complete and verify the setup.
Physically Installing the Unit and Setting Up for
Remote Access
It is assumed that frame relay service is turned on at the site.
Procedure
1
Follow Step 1 through
2
If the DSX-1 interface will be used, install the DSX-1 cable (see
Interface
on page 25).
3
Install the DTE cables (see
4
Install the modem cable (see
5
If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see
the ISDN Interface
6
If required, connect the Ethernet port to the LAN (see
page 28).
Physical installation of the unit is complete; the NOC can now remotely access the unit for
additional configuration.
Completing Setup of the Unit From the NOC
Procedure
1
Access the remote iMarc unit using the dedicated management link, using the Node IP
Address that was entered (see
Access
on page 15).
2
Configure specific frame relay options, like CIR (committed information rate), and any
other configuration options requiring input or changes from the default settings.
3
Configure each interface according to the local management interface (LMI) and assigned
line conditions supplied by the service provider.
Configuration → Network → Frame Relay
Configuration → Data Ports → Frame Relay
4
If SNMP traps are wanted, set up managers, select the desired traps, and configure trap
dial-out if desired (see
9126-A2-ZN11-40
Step 8
of
Full Installation and Setup
Connecting to a DTE (Router or FRAD)
Connecting the Modem
on page 28).
Physically Installing the Unit and Setting Up for Remote
Configuring SNMP Trap Managers and Trap Dial-Out
on page 12.
Connecting to the DSX-1
on page 26).
on page 27).
Connecting the Ethernet Port
Connecting to
on
on page 22).
15
Advertisement
Table of Contents
