Add An Ipoe Wan Service - Zhone 6519-X1 User Manual

7. Click Next.
8. On the Routing — Default Gateway page set the priority of WAN interfaces used as default
gateways then click Next
If multiple WAN interfaces are configured, you can define the priority by their position in the
Selected Default Gateway Interfaces window. Top is the highest priority; bottom the
lowest.
Change the priority order by removing all items from the Selected Default Gateway
Interfaces window by selecting them, then clicking the right arrow button. Select the items in
the priority order, then click the left arrow to move them into the Selected Default Gateway
Interfaces window.
9. On the DNS Server Configuration page set the priority of WAN interfaces to be used as
DNS server interfaces, or specify a static DNS Primary and Secondary server, then click
Next.
If multiple WAN interfaces are configured, you can define the priority by their position in the
Selected DNS Server Interfaces window. Top is the highest priority; bottom the lowest.
Change the priority order by removing all items from the Selected DNS Server Interfaces
window by selecting them, then clicking the right arrow button. Select the items in the priority
order, then click the left arrow to move them into the Selected DNS Server Interfaces
window.
For a Static DNS IP Address, enter a primary and secondary DNS server for your modem,
10. On the WAN Setup – Summary page, review your settings and click Apply/Save to accept
the settings. To change your settings, click the Back button on the WAN Setup – Summary
page (do not click the browser Back button).
In the Wide Area Network (WAN) Service Setup page, you will see the new WAN interface
added.

Add an IPoE WAN Service

1. Add an EoA Layer 2 interface as described above (Add a Layer 2 Interface).
2. Under Advanced Setup click WAN Service then click Add
Address text box which is displayed when the Use Static IPv4 Address check box is
selected.
Enable PPP Debug Mode: Used to debug PPPoE issues. Use only when instructed by
your ISP.
Enable KeepAlive: Enables/disables TCP keep alive packets.
KeepAlive Timer: When Enable KeepAlive is selected, this input box indicates how
often the device should send keep alive packets.
Max Fail: Number of times the router should re-attempt PPPoE authentication after a
failure.
Bridge PPPoE Frames Between WAN and Local Ports: By default the bridge PPPoE
frame between WAN and local ports is on. This allows a PC behind the modem to be the
PPPoE termination point. PPPoE authentication is passed on to the PC instead of to the
router. If there are multiple PCs then, each one will have a PPPoE authentication. Note
that this option is not applicable for PPPoA.
Enable IGMP Multicast Proxy: Configures the router for IGMP snooping so the router
can keep limit multicast traffic.
65xx-A1 Family Router Users Guide
43