Sanyo S103 Getting Started page 90

Connectivity
Receiving data (Data Reception
Mode)
This function enables the phone to
be ready to receive data trans-
ferred from another device.
1 In Standby mode, press O,
highlight and press O.
2 Select Connectivity and press
O.
3 Select Bluetooth and press O.
4 Select Data Reception Mode,
press O and press [YES]. The
other device then starts
transmitting data into your
phone.
Note: Just after receiving the data, a
selection window appears and
requests you to select Save or
Cancel.
180
Exchanging My Numbers
1 Open the Bluetooth display.
• Press O → → Connec-
tivity → Bluetooth
2 Select Exchange My Numbers
and press O.
Go to the steps below.
Receiving second party My
Numbers
3 Select Receive after step 2
above, press O, and press
[YES]. Receiving starts.
Sending your My Numbers
3 Select Send after step 2 above,
press O and press [YES].
4 Press [Search] to search for a
target device and press O
once found.
5 Select the device and press O.
Using the Handsfree Mode via
Bluetooth™
The hands-free device can be
wirelessly connected to the phone
via Bluetooth™.
You can make and receive a call
operating the hands-free device.
Read your Handsfree Mode user
manual before using.
Configure both devices
1 Turn on the Bluetooth™
reception mode on the
Handsfree Mode.
• On the S103, press O →
→ Connectivity →
Bluetooth → Handsfree
Mode
2 Select Connect to Hands-free
or Connect to Headset and
press O.
Connectivity
3 Press [Search] and O once the
device is found.
4 Select the device and press O.
5 Enter the Bluetooth™ pass-
word when prompted and
press O.
Tip: If the Hands-free device is already
on standby for receiving, you can
immediately try connecting the
phone to the Hands-free device.
Press [OK] to start the connection
operation.
Cancelling/disconnecting the
connection
You can cancel "standby for
receiving" and disconnect the
already established connection.
1 On the S103, press O →
→ Connectivity → Bluetooth
→ Handsfree Mode
181