Sanyo S103 Getting Started page 19

Video call
Adjusting the brightness or
white balance
You can adjust the brightness or
white balance of the image you
are sending.
1 Press [Options], select Settings
and press O.
2 Select Brightness or White
Balance and press O.
3 Adjust the brightness using u /
d, or adjust the white balance
by selecting Auto, Sunny,
Cloudy, Electric Lamp,
Fluorescent 1, or Fluorescent
2 and pressing O.
38
Reducing flicker
Occasionally the image may flicker
due to less than optimal local
frequency. You can use the
"Flicker-free" function to reduce
this problem. Flicker is likely to
occur when you move between
areas using different frequencies
(50 hertz or 60 hertz).
Note: It is possible that the flicker may
not be removed completely
even after you changed this
setting. However, this is not
considered to be a problem with
the phone.
1 Press [Options], select Settings
and press O.
2 Select Flicker-free and press
O.
3 Select 50Hz or 60Hz to best
suit your local environment.
Sending a video stored in the
Gallery
You can retrieve a video or picture
stored in the phone and send it to
the other party during a video call.
See p. XX for details about the
Gallery.
1 Press [Options], select Send
and press O.
2 Select either Picture or Video
and press O.
3 Select a video or picture from
the Gallery and follow the
instructions on your S103.
Note: Copyright restricted images may
not be displayable.
Activating Hands-free
This function raises the sensitivity
of the microphone and increases
Video call
the volume of the speaker
temporarily so that you can talk
hands-free. The setting changed
here returns to the previous one
when you finish the video call.
(See also p. XX)
• Press [Options], select Hands-
free On and press O. To
deactivate hands-free, repeat
the same step above and select
Hands-free Off.
Activating/Releasing Call hold
• Press [Hold]. Puts the con-
nected caller on hold until you
are ready to resume talking.
Note: After putting the call on hold,
press (or O or [Answer]) to
resume talking.
39