Table of Contents
Advertisement
AT8901
1.3
Software Support
The following table contains information related to software supported by the AT8901.
Table 1-4:
AT8901 Software Specification
General
Ethernet/Bridging (Base
fabric switch)
Routing
•
Reliable field upgrades for all software components
•
Dual boot images with roll-back capability
•
Management via SNMP and Command Line Interface
•
System access via TELNET, SSH and serial line
•
Hot-Swap support
•
Hot-Plug support for AMC modules
•
Redundancy support for base fabric switch
•
IP router on the base fabric
•
Support for managing the optional SETS AMC module
•
Modular software architecture to enable project specific customization
•
Static link aggregation (IEEE 802.3ad) on uplink ports
•
Classic and rapid spanning tree algorithms supported (IEEE 802.1D, IEEE 802.1w)
•
Quality Of Service on all ports (IEEE 802.1p)
•
Full Duplex operation and flow control on all ports (IEEE 802.3x)
•
Static MAC filtering
•
Port Authentication (IEEE 802.1X)
•
Auto negotiation of speeds and operational mode on all external GbE interfaces as
well as on all base fabric interfaces
•
Layer 2 multicast services using GARP/GMRP (IEEE 802.1p)
•
VLAN support including VLAN tagging (IEEE 802.3ac), dynamic VLAN registration
with GARP/GVRP (IEEE 802.1Q) and Protocol based VLANs (IEEE 802.1v)
•
Double VLAN tagging
•
Port Mirroring
•
Redundancy of routing functionality using a second switch hub board
•
IPv4 Forwarding on all base channels and connected uplink ports
•
Quality of service according to the DiffServ standards
•
ARP for all routable interfaces
•
ICMP for all routable interfaces
•
OSPF routing protocol version 2
•
RIP routing protocol version 2
•
VRRP (virtual router redundancy protocol) for transparent fail over of default routers
•
IGMP snooping
Page 1 - 11
SPECIFICATIONS
Introduction
AT8901 User Guide
Advertisement
Table of Contents
