Warning Messages; Error Messages - FALEX 430 ETR Operation Manual

5: Maintenance /Service

Warning Messages

[ This is not a complete list, these are commonly encountered Warning Messages, for any other Warning Messages
please contact your Falex Representative or Compass Service ]
Message
Device not calibrated.
Please Calibrate!
No Camera Settings File
Found!
No Parameter File
Found!

Error Messages

[ This is not a complete list, these are commonly encountered Error Messages, for any other Error Messages please
contact your Falex Representative or Compass Service ]
Message
Shutter Not Closed
Init aborted. Please
Restart the device.
Condition
The file 'CalibrationData.cal'
doesn't exist in the HMI folder.
The file 'CameraSettings.param'
wasn't found in the HMI folder.
The file '
DeviceParameters.param
wasn't found in the HMI folder.
Condition
Shutter is not closed. Left Limit
Switch is not triggered.
Initialization was aborted when
HMI was loaded.
Effect
No measurement can
be started.
No standard settings
for the camera can
be loaded in the
Camera Settings
Screen
' Device parameters
can't be reset to
standard settings.
Effect
No measurement can
be started.
Device can be used as
Normal, but it is
Recommended to
Restart the device to
Restart the
Initialization.
45
Comments
Contact Falex Rep/Compass
Service
Contact Falex Rep/Compass
Service
Contact Falex Rep/Compass
Service
Comments
Refer to Section 3.5.7 'Shutter'
Or Contact Falex Rep/Compass
Service
Refer to Section 3.5.7
'Start Initialization' or
Contact Falex Rep/Compass
Service