Forward Safety And Safety Labels Description - FALEX 430 ETR Operation Manual

Forward
This manual provides information and procedures to safely install, operate, and maintain the Falex
430 ETR (
also known as the Falex 430 Ellipsometer
read, understand and observe the safety instructions described in this manual.
Keep this manual with the machine. If you lose this manual or need an additional copy, please contact
Falex Corporation. The information contained in this manual was based on machines in production at the
time of publication. Falex Corporation reserves the right to change any portion of this information without
notice. This operation manual is divided into sections and addenda as listed in the 'Table of Contents'.
Safety Introduction
The following safety precautions are published for your information. This manual does not purport to
detail all of the safety concerns, if any, associated with the equipment's use. It is the responsibility of the
operator of this equipment to establish appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use. This machine is built with operator safety in mind;
however, it can present hazards if improperly operated. Follow operating instructions carefully! If you
have questions about operating this equipment, please contact Falex Corporation.
Note: This equipment should only be operated by personnel trained by Falex or a Falex approved
distributor.
Note: This equipment is to be serviced or repaired by factory authorized personnel only!
recommended that for any service related issues, this equipment is to be returned to the
manufacturer.
Note: This equipment is not to be opened or modified in any way by the customer.
This manual may contain HAZARD, WARNING, and CAUTION callouts, which must be followed to reduce
the possibility of personal injury, damage to the equipment, or improper service. This machine must be
electronically grounded. Do not change the grounding requirements of the machine.
Machine Safety Labels and Manual Safety Callouts
The following are safety labels may be placed in areas on the test machine that may be hazardous to the
operator. These same symbols may be used in the manual to bring attention to safety concerns. Please
take caution and understand what these labels indicate before operating the test equipment.
). For your own safety and protection from injury, carefully
ELECTRICAL SHOCK HAZARD: This symbol indicates hazardous voltage
is present. Turn main power button off and switch off the main
breaker ( right side of unit
be serviced by trained personnel only.
4
) before taking sides off of unit. This unit is to
It is