Programming - Screen Innovations Solo/Pro 2 Installation Instructions Manual

PROGRAMMING - 24V RTS
Setting the Drop - Solo/Pro 2 is factory preset to have
1" of drop, the distance between the top of the viewing
area and the cassette. The drop can be changed to
be up to the MAX DROP (see model number or order
information for your screen's max drop) to customize
the viewing surface's vertical position. To adjust the
drop, do the following:
1. Press the down button on the RF remote to send the
screen to its lower limit and wait untill it stops there.
Screen must be at its current lower limit before you
can alter it.
2. Hold the UP and DOWN buttons simultaneously until
the screen jogs once.
3. Use the DOWN and UP buttons to position the
viewing area vertically, up to Max Drop from the
bottom of the cassette.
Programming - 24v RTS
DO NOT set the lower limit (top of viewing) more
than MAX DROP from the cassette. Doing so risks
damaging the screen material.
4. Once the viewing area is positioned, hold the middle
square STOP button until the screen jogs once. This
saves the new lower limit. If this Step is not
completed, the screen will jog once after about 3
minutes, indicating that its no longer in program
mode, and the motor will only recall the previous
lower limit. No changes will be saved.
1" Factory default drop
18 Programming - 24v RTS
Drop - Can be set up to
MAX DROP
19