Initial Inspection; Positioning The Projector - Barco FL40 series User Manual

250mm
Image 4-1

4.3 Initial inspection

General
Each projector is inspected and rigorously tested at our production facility to ensure that it is free from any
mechanical or electrical defects.
Upon receipt of the projector, we recommend that customers inspect the projector for any signs of damage
that may have occurred in transit. If damage is found, file a claim with the shipping carrier immediately. Notify
the Barco Sales and Service office, or your preferred Barco agent, of the damage as soon as possible.
Box Contents
Your projector box should contain the following:
• Projector unit
• Power cord. (Not all power cords are supplied, see note below).
• Quick start guide
• Safety manual
• Remote Control
If the power cord for your region is not supplied, ensure that the power cord that will be used is
according to the regulations for your region. The power cord must be of 3 lead type, where one of
the leads is ground. Se also the Safety and Environment Information, chapter 1.2 in this document.
The projector lens is delivered in a separate box.

4.4 Positioning the projector

CAUTION: The position and physical securing of the projector must be sufficient to prevent it from
accidental or involuntary movement. Proper securing of the projector is the responsibility of the
installer and user. The Projector are heavy, and can cause severe damage and injuries if falling.
250mm
R5910123 /00
Physical installation
FL40 / FS40 Projectors 37