Communication; Apply A Menu Theme; Standby Eco - Barco FL40 series User Manual

System settings menu

9.1 Communication

About
System settings / Communication
Network connection is required to communicate with the projector via LAN or Internet.
Current Ethernet communication information is given, and can be edited in this menu.
Default mode for Ethernet communications are: Automatic ON / IP Version 4 DHCP mode.
Setting
Automatic
ON
OFF
IP version 4
Static mode
DHCP mode
Image 9-1
Manually set up the IP adress
Go to the menuSystem settings / Communication / LAN
Enable the Auto zone on the display and press enter. The Auto zone will change to "Manual".
Scroll down, and modify the desired fields. When in the desired fields, press "Enter" to enable the virtual
keyboard, enter the desired values, and press "Enter" again to confirm the change.

9.2 Apply a menu theme

About
System settings / Themes
Themes are used to apply a predefined functionality to the OSD display. There are two options: light (default)
or dark. (From software version 1.5, the "Dark" theme is the default.)
It is the "Light" option that is shown in the menu screenshots in this manual, as this gives a better rendering.

9.3 Standby ECO

About Standby ECO
When the ECO mode is enabled, the projector will automatically go to ECO standby mode after a time-out
(default 15 minutes). All electronics (including fans, pumps, ...) go down except for a very small wake-up
controller. See section dedicated to the Power Mode transitions for further details.
106 R5910123 /00 FL40 / FS40 Projectors
Description
DHCP enabled
Static
Set address, subnet mask and default gateway according to network
specification.
Assigned IP address, subnet mask and gateway.