OM POWER OM2000A+ Instruction Manual page 33

ll the warning and fault messages are stored in the memory. You can display particularly warning
messages and particularly error messages. They are stored one by one to the memory. You can see
them on the display. If memory is full, every new message will delete oldest one and move rest of them
one position back. It means that every time last 20 messages are visible on the display.
In the case of some hardware failure or if your power amplifier is not working properly, please contact
the manufacturer or your dealer.
Never try to change or move any part inside the amplifier except of tube or fuses.
Substitution of parts may void intrinsic safety!
Dealer in the USA:
Array Solutions
2611 North Belt Line Road
Suite # 109
Sunnyvale, TX 75182
Tel: (214)954-7140
Email: sales@arraysolutions
This an example from previous attempt,
Type of supported TCVR and
when antenna was disconnected from the
PA during transmitting.
frequency are visible on the
Reflected power was higher than 250W,
warning message "Reflected power too
high" appeared.
AUTO LED is ON.
If you touch the yellow box, warning details
Type of supported TCVR and
will be visible.
frequency are visible on the
AUTO LED is ON.
.
com
working
display.
working
display.
33