Phantom Product Back Interface - Pylontech Phantom-S Product Manual

PHANTOM Product Back Interface

Power Switch
Power Switch: BMS standby, no power output
RUN
RUN LED: to show the Power Switch is ON, and the equipment has electricity.
ADD Switch (5)
ADD Switch: 4 ADD switches, Dip1
9600). Nether position is OFF, means "0". Upper position is ON, means "1". "0000"
setup the baud rate 115200, and "1000" setup the baud rate 9600. The settings
will be active only after restart the battery.
The slave battery's address will be assigned automatically. 1 master battery can supervise 7 slave
batteries (maximum 8 batteries in each battery group). Multiple battery group should setup the master
batteries' ADD switch. (Refer to Chapter 4 / D)
Dip2 Dip3
0 0
1 0
0 1
1 1
0 0
1 0
0 1
1 1
Console
Console Communication Terminal: (RJ11 port) follow RS232 protocol, for manufacturer or professional
engineer to debug or service.
18PISV0805
o t d f e
Dip4
0 0 : Single battery group's master battery should setup as this.
th
0 1 st : 1 st battery group's master battery should setup as this.
0 2 : 2 battery group's master battery should setup as this.
nd nd
0 3 : 3 battery group's master battery should setup as this.
rd rd
1 4 : 4 battery group's master battery should setup as this.
th th
1 5 : 5 battery group's master battery should setup as this.
th th
1 6 : 6 battery group's master battery should setup as this.
th th
1 7 : 7 battery group's master battery should setup as this.
th th
i n i e t d f i e f e r t n b a u d a r e t
Group Address Number
7 / 22
0 ( s i 1 1 5 2 0 , 0 1 is
ON
OFF