Under Ethernet Communication Between Mbms And Bms (Battery String Qty. 1~32 Set) - Pylontech PowerCube-M1 Product Manual

Note: X address should correspond with CAN1 port, X
1
port.
The BMS's first five bits must set in below <BMS's Address Configure
Table>. The last BMS's terminal resistance must set in "1" (X=1), and
other BMS's terminal resistance must set in "0".
The address is configured follow ASCII code: ("X" is terminal
resistance).
BMS's Address Configure Table:
Battery
Address Bit
String
1 10000X
2 01000X
3 11000X
4 00100X
5 10100X
6 01100X

Under Ethernet communication between MBMS and BMS (battery string qty. 1~32 set)

The MBMS's ADD Switch set with "0000X
port communicate with only one another equipment, if this equipment uses terminal resistance
then X should be "1", if this equipment uses without terminal resistance X
1
the CAN port communicate with multi equipments, if this equipments uses terminal resistance
then X should be set follow the CAN bus condition.
1
Note: X address should correspond with CAN1 port, X
1
port.
The BMS's first five bits must set in above <BMS's Address Configure
Table>. The other BMS' terminal resistance must set in "0".
The address is configured follow ASCII code: ("X" is terminal
resistance).
BMS's Address Configure Table:
address should correspond with CAN0
0
X ". The last 2 bits are terminal resistances. When the CAN
1 0
address should correspond with CAN0
0
13 / 15
should be "0"; If When
1
18 PIMP0801