Installing The Antenna (Home/Office); Installing The Signalboost™ Amplifier (Home/Office) - Wilson Electronics SignalBoost 811210 Installation Manual

Installing the Antenna
To receive the best cell signal, select a window location at least 12 inches away from any
radio or television antennas and free of obstructions.
Installing the Wilson SignalBoost™ Amplifier
Home/Office Installation
Using the suction cups, position the
mounting bracket on the window at a height
convenient to where the amplifier will be
located, then attach the antenna to the
bracket.
The antenna must be installed vertically.
Signal performance will be degraded if the
antenna is not vertical.
!
Warning: The antenna used with this
amplifier must have a separation distance of at
least 11 inches from all persons.
!
Warning: Do not plug in the AC power
supply until the outside antenna and universal
connector cables are attached to the amplifier.
Select a location to install the amplifier that
is away from excessive heat, direct sunlight
or moisture and that has proper ventilation.
Recommended installation locations are:
• On a desk or table top
• In a bookshelf
• On the floor
Run the cable from the mini magnet-mount
antenna and attach it to the FME-Male
connector labeled "outside antenna" on the
amplifier.
Attach the universal connector cable to the
extension cable and attach the extension
cable to the FME-Male connector labeled
"Universal Connector" on the amplifier.
Then attach the universal connector to your
cell phone or data card.