Page 2
Returned Material Authorization (RMA) number supplied by Wilson Electronics. Wilson shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer.
Wilson Electronics manufactures a wide variety of antennas to help you customize your amplifier for your specific application. Several are shown below. See your dealer or visit www.wilsonelectronics.com.
Before Getting Started This guide will help you properly install Wilson’s SignalBoost Vehicle Wireless amplifier. It is important to read through all of the installation steps for your particular application prior to installing any equipment. Read through the instructions, visualize where all the equipment will need to be installed and do a soft installation before mounting any equipment.
Installing a Wilson Outside Antenna To receive the best cell signal, select a location in the center of the vehicle’s roof 12 inches away from any other antennas and free of obstructions. Follow the specific antenna installation instructions included with the outside antenna (sold separately).
Installing a Wilson Amplifier Warning: Do not plug in the DC power supply until the outside and inside antenna cables are attached to the amplifier. Select a location to install the amplifier that is away from excessive heat, direct sunlight or moisture and that has proper ventilation.
Wireless Installing a Wilson Inside Antenna Install the Ultra-slim inside antenna 8-12 inches from where the cell phone is located or directly on the cellular data card or laptop. Amplifier Ultra-slim Antenna Warning: Do not install the Ultra-slim antenna within four inches of metal. (Metal found inside the vehicle’s seat will not affect the antenna’s performance.) Place the inside antenna on the side of the...
Laptop or Data Card Attaching a Wilson Ultra-slim Inside Antenna to a Laptop or a Cellular Data Card Amplifier Ultra-slim Antenna The Ultra-slim antenna must be placed on or near the cellular data card to work properly. Attach the Ultra-slim antenna to the laptop or cellular data card with the VELCRO ®...
Powering up a Wilson Amplifier Make sure both the outside and inside antenna cables are connected before powering up the amplifier. Connect the power cable from the DC plug-in power supply to the amplifier and insert the large end into DC power socket (the cigarette lighter outlet.) Warning: Use only the power supply provided in this package.
Warnings and Recommendations Warning: In a wireless installation, do not plug the amplifier directly into the cell phone or cellular data card using an antenna adapter. It will damage the cell phone or cellular data card. Warning: Do not plug in the DC power supply until the outside and inside antenna cables are attached to the amplifier.
About Wilson Electronics Wilson Electronics, Inc. has been a leader in the wireless communications industry for nearly 40 years. The company designs and manufactures amplifiers, antennas and related components that significantly improve cellular telephone signal reception and transmission in a wide variety of applications, both mobile and in-building.
Amplifier Specifications Dual Band 800/1900 MHz Specifications Model Number / Part Number 271230/801230 Connectors SMA Female Impedance (input/output) 50 ohms Dimensions 3.8 X 3.2 X 1.5 inch or 9.6 X 8.1 X 3.8 cm Weight 4 oz or 0.11 kg...