Triton T300si Installation And Operating Instructions Manual page 28

Fig.41
Mark the
position where
rail enters
the ceiling
Guide bracket
Riser rail
Fig.42
Fig.43
Ceiling trim
Riser rail
Guide bracket
Fig.44
Riser rail
Retaining
screw
T300si wireless remote electric shower
Spacer
Bottom
bracket
26
Slide the riser rail up through the guide bracket
until it touches the ceiling (Fig.41). Using a
spirit level, align the riser rail vertically and mark
the centre hole position of the rail on the ceiling.
Remove the rail.
Using a 26 mm hole cutter, drill the ceiling
opening.
Fit the riser rail into the bottom bracket and
secure with the small screw supplied.
IMPORTANT: Before securing the rail to the
bracket, test fit the outlet connector and clip
to make sure they will fit into the bottom
bracket with the rail in place.
Feed the riser rail assembly through the base of
the guide bracket and into the ceiling opening.
Using a spirit level, align the riser rail vertically
and mark the bottom bracket centre hole
position.
IMPORTANT: Remember to add the extra
length of rail to the measurements to clear
any obstructions above the ceiling level
(Fig.40) before marking.
Remove the assembly then drill and plug the
wall.
Slide the hose retainer onto the riser rail section.
Fit the showerhead holder onto the riser rail
section, press and hold the button on top of the
holder to release the locking mechanism, then
slide onto the rail (Fig.42). Release the button to
lock the holder in place.
Fit the riser rail through the guide bracket
before sliding the ceiling trim over the rail end,
and feeding the rail into the ceiling opening
(Fig.43).
Secure the rail and bottom bracket assembly to
the wall using the appropriate retaining screw
supplied (Fig.44).
Slide the ceiling trim up to the ceiling.