Triton T300si Installation And Operating Instructions Manual page 18

Fig.16
Fig.17
Fig.18
T300si wireless remote electric shower
16
Note: If the remote pack is to be mounted in a
loft or airing cupboard where the ceiling or wall
has metallic backing on the plasterboard then it
may be necessary to remove a small section of
the metallic backing to enable communication
between the control panel and the remote pack.
Removing an area of about 50 x 50 cm of the
metallic backing from the ceiling or wall along
the line of signal transmission, between the
remote pack and the control panel, should be
sufficient to enable correct communications.
Procedure
Unscrew the top and bottom retaining screws
(Fig.16) and lift cover from the backplate. To
allow access to the pipe and cable connections,
remove the two screws (Fig.17) and take off
the trimplate.
After choosing the site for the shower, use the
backplate as a template and mark two fixing
holes (Fig.18).
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Screw top fixing screw into position leaving the
base of the screw head protruding 6 mm out
from the wall.
Entry positions for the mains water are from the
bottom or from the rear.
Cable entry is via the top or rear.
Note: Deviations from the designated entry
points will invalidate product approvals.
If a bottom surface entry is required for the
mains cold water then the necessary hole will
need to be cut out in the trimplate and cover
(Fig.19).
If a surface cable entry from the top is required
then the relevant hole in the backplate will need
to be cut out (Fig.20).
Hook the backplate over the top screw and fit
the bottom fixing screw into position.
DO NOT fully tighten the screws at this stage,
as the fixing holes are elongated to allow for
out of square adjustment after the plumbing
connections have been completed.