Connect To Ac Power - Allen-Bradley 2711P Technical Data Manual

20 Wiring and Grounding Guidelines for PanelView Plus Terminals
Table 13 - Wire Specifications for AC Power Terminal Block
Terminal
400 and 600
Copper
Stranded or solid
(1)
700 to 1500
(1) Includes PanelView Plus 6 terminals and PanelView Plus terminals supporting FactoryTalk View ME software, version 5.1 or earlier.
(2) Two-wire maximum per terminal.
PanelView Plus 6 (700 to 1500) Terminals
Other PanelView Plus 700 to 1500 Terminals Look Similar
Functional Earth/Ground to Bus

Connect to AC Power

PanelView Plus terminals with an AC power input have these power ratings.
Table 12 - AC Power Ratings
Terminal
400 and 600
(1)
700 to 1500
(1) Includes PanelView Plus 6 terminals and PanelView Plus terminals supporting FactoryTalk View ME software,
version 5.1 or earlier.
The input power terminal block supports these wire sizes.
Wire Type Dual-Wire Gauge
0.3...1.3 mm
22...16 AWG
Cu 90 °C (194 °F)
0.3...1.3 mm
22...16 AWG
Follow these steps to connect the terminal to AC power.
1. Verify that the terminal is not connected to a power source.
2. Secure the AC power wires to the terminal block.
Follow the markings on the terminal block and terminal for proper
connections.
3. Secure the protective earth/ground wire to the marked position on the
power input terminal block.
4. On 700 to 500 devices, also secure the functional earth/ground wire to the
functional earth terminal screw on the back of the display to ground bus.
Figure 10 - AC Power Connections
L1
L2/Neutral
Protective Earth
to Ground Bus
Rockwell Automation Publication 2711P-TD001D-EN-P - February 2011
Voltage Range Frequency
85...264V AC 47...63 Hz
85...264V AC 47...63 Hz
(2)
Single-Wire Gauge
2 2
0.3...2.1 mm
22...14 AWG
2 2
0.3...2.1 mm
22...14 AWG
PanelView Plus 400 and 600 Terminals
VA
60VA max
160VA max
Terminal Screw Torque
0.45...0.56 N•m (4...5 lb•in)
0.56 N•m (5 lb•in)
L1
L2/Neutral
Protective Earth
to Ground Bus