Allen-Bradley 2711P Technical Data Manual page 6

6 Wiring and Grounding Guidelines for PanelView Plus Terminals
PanelView Plus 700 to 1500 Terminals
The terminal block installed in the 700 to 1500 terminals depends on the series
of the logic module and the power input type.
Table 1 - Power Terminal Block
Power This Terminal
Input Block is Used
DC 2-position
3-position
AC 3-position
(1) These logic modules support FactoryTalk View Machine Edition software, version 5.1 or earlier.
Follow these steps to remove the terminal block.
1. Loosen the two screws that secure the terminal block.
2. Gently pull the terminal block away from the connector.
2-position DC Terminal
Follow these steps to install the terminal block.
1. Reattach the terminal block to the connector until seated.
2. Tighten the two screws that secure the terminal block to the connector.
Rockwell Automation Publication 2711P-TD001D-EN-P - February 2011
With This Device
• Series A or later PanelView Plus 6 logic modules
• Series E or later PanelView Plus logic modules
• PanelView Plus Compact 1000 terminals
• Series A-D logic modules (PanelView Plus)
• All terminals and logic modules with an AC power input
3-position AC or DC
(1)
(1)