Using The Pressure Washer; Automatic Stop System; Release The Trigger Lock - Clarke KING150 Operation & Maintenance Instructions Manual

USING THE PRESSURE WASHER

AUTOMATIC STOP SYSTEM

The Automatic Stop System stops the hot washer during the bypass phase.
Once the hot washer is switched on, the 'Automatic Stop System' will start and
stop the hot washer automatically whenever the trigger is pulled / released.
Sometimes the hot washer may start without pressing the gun trigger, this is
normally due to air bubbles in the water or other similar phenomena which do
not imply the existence of any defects in the hot washer.
Do not leave the hot washer unattended during the bypass phase for more
than 5 minutes. If you need to leave the hot washer for longer than this, switch
it off first, and operate the trigger to release the pressure.
STARTING UP
1. Connect the plug to the power
socket.

RELEASE THE TRIGGER LOCK

1. To release the trigger lock, lift the
lock upwards and lay it against
the trigger as shown.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9