Advertisement
PAGE
9
Remove the heater. Discard flexible air tube to the air inlet flange.
Lay heater on the floor and disconnect cable to the fresh air door.
Discard the hardware.
Disconnect electrical harness from the resistor and blower motor.
Remove the inlet air flange. Discard flange and original mounting hard-
ware.
Locate the air inlet block off and (4) #10 x ¾" tek screws.
Attach the block off over the inlet hole as shown, using (4) #10 screws.
www.classicautoair.com • 866.435.7801
Advertisement
