Advertisement
PAGE
25
Locate the Receiver / Drier, hi/low pressure switch, Drier Mounting bracket, and (2)
#10 x ¾" tek screws.
Attach pressure switch to the drier and then the assembly to inner fender liner behind
battery box
using the (2) # 10 x ¾" tek screws.
Locate the short #6 liquid hose and (2) #6 o-rings.
Attach hose to bulkhead fitting from the condenser tube. Route hose up in front of
battery and attach to inlet on the drier using (1) #6 o-ring and a few drops of mineral
oil.
Tighten all fittings securely.
Locate remaining #6 liquid hose assembly and (2) #6 o-rings.
Attach 90 deg end to drier and route hose along fender well and the 45 deg end to
bulkhead fitting on the firewall.
Use the (2) #6 o-ring and a few drops of mineral oil.
www.classicautoair.com • 866.435.7801
Advertisement
