Advertisement
PAGE
11
Locate the new controls and blower switch from the control sack kit.
Remove the first nut and position the back nut ¼" from the end of the threads.
Install blower switch with the blower trim ring through the center hole and attach
with the switch nut previously removed.
Be sure switch is in the off position and the flat is pointing down.
Locate the control cable assembly with the ring on the end. Attach cable through
the left hole along with the "Temp" trim ring. Use the switch nut provided.
Locate the last of the control cables and the "Defrost" trim ring. Attach cable
through right hole and the defrost trim ring. Use the switch nut provided.
Attach the knobs provided using an allen wrench as shown.
www.classicautoair.com • 866.435.7801
Advertisement
