Advertisement
PAGE
23
Slide condenser assembly so that condenser is on engine side of
the radiator support with the mounting brackets between the
support and the grille.
Note: Condenser top edge should be even with top
of the radiator support.
Attach tube assemblies to the condenser fittings using o-rings
and a few drops of mineral oil for each connection.
Locate (2) #14 x ¾" tek screws.
Install lower condenser mounting brackets to radiator support
using the #14 screws as shown.
Locate remaining condenser mounting brackets, (4) #10 x 3/8"
hex head screws, and (2) #14 x ¾ tek screws.
Attach brackets to condenser using #10 screws and bracket to
the radiator support using the #14 screws.
www.classicautoair.com • 866.435.7801
Advertisement
