Advertisement
PAGE
24
Reinstall radiator, fan shroud and fan using the original hardware.
Note: It will be necessary to trim the fan shroud around the compressor clutch.
Locate the discharge hose and (2) #8 o-rings.
Attach end with service port to the compressor using (1) #8 o-ring and a few drops of
mineral oil.
Other end attaches to #8 bulkhead fitting on the radiator support using (1) #8 o-ring and a
few drops of mineral oil. Tighten securely.
Locate the #10 suction hose.
Attach end of hose with the service port to the compressor using (1) #10 o-ring and a few
drops of mineral oil.
Route suction hose from compressor to #10 fitting at the firewall.
Attach to the fitting using (1) #10 o-ring and few drops of mineral oil.
Locate (1) hose clamp, and (1) #10 x 3/4" tek screw from the condenser kit.
Attach suction hose to firewall using the clamp and screw.
www.classicautoair.com • 866.435.7801
Advertisement
