Advertisement
PAGE
13
Locate 2" dia x 24" (1pc), 2" x 36" and 2" x 48" flex hose from the unit box.
Cut (1) pieces (1) 20" long, (1) piece 35" long, and (1) piece 45" long.
Attach over the outlets as shown.
Locate (2) 2 ½" to 2" flex hose adapter and (4) #8 x 3/8" pan head screws from the hardware sack
kit.
Attach to the ends of the 20", and 35" flex hose. Using (2) of the #8 screws for each connection.
Locate the blower support bracket and (2) #8 x 3/8" pan head screws from the hardware sack kit.
Attach bracket to top of the blower motor as shown, using the (2) #8 screws.
Locate the wire harness from the unit box.
Route the harness over top of the unit and connect blue wires to the thermostat and micro switch.
Other end will plug into the blower motor connector.
Long blue wire is the clutch wire. This will go through firewall out to the compressor .
www.classicautoair.com • 866.435.7801
Advertisement
