Advertisement
PAGE
15
Carefully slide unit behind the glove box.
Locate (2) ¼-20 x 1" hex head screws.
Attach drivers side of the unit through holes in the firewall
that was previously drilled, and into the ¼-20 j-clips as
shown.
Locate (1) #14 x 3/4" tek screw from the hardware sack kit.
Holding evaporator level with edge of the dash attach
blower bracket to the air box using #14 screw as shown.
Locate (1) #10 x ¾" tek screw. Attach ground from blower
motor to body next to the blower support.
NOTE: The routing of the flex hose and the door cable.
www.classicautoair.com • 866.435.7801
Advertisement
