PAGE
16
Locate (1) ¼-20 x 5/8" hex head screw from the hardware sack kit.
Insert screw from engine side of firewall and attach to the rear support brace.
Tighten the screw on back of the unit.
Route 20" flex hose with the hose adapter to passenger defrost diffuser. Attach
adapter over
diffuser using the clips on the adapter.
Route 35" flex duct with the hose adapter to drivers defrost diffuser. Attach adapter
over diffuser using the clips on the adapter.
Locate the remote heat dump and (2) #10 x ¾" tek screws from the main box.
Attach heat dump to firewall just to left of the clutch pedal using (2) #10 tek screws.
Route 45" flex hose over the steering column and attach to the heat dump.
Locate (1) #8 x 3/8" pan head screw from the hardware sack kit.
Route control cable and insert end of cable into second hole from the pivot of the
crank arm
Attach using the #8 screw.
www.classicautoair.com • 866.435.7801