Advertisement
PAGE
18
Located behind the glove box opening.
Attach the two hoses to the heater connections on the unit using (2) worm gear
clamps provided.
LIQUID HOSE
Tighten securely.
Locate the liquid hose (smallest), suction hose (largest), and (2) bulkhead plates
from the hardware sack kit.
Insert bulkhead fittings through (1) the bulkhead plate and then through the
firewall.
On engine side of the firewall attach second bulkhead plate over the fittings and
use the fitting nut and rubber seal to attach. Tighten securely.
Route smallest hose up and around blower and attach to the expansion valve
using (1) #6 o-ring and a few drops of mineral oil.
Route largest of the hoses around blower and attach to the unit using (1) #10
o-ring and a few drops of mineral oil.
www.classicautoair.com • 866.435.7801
Advertisement
