Indicator Lamp In The Charging Station - Husqvarna 115H Operator's Manual

6.4 Indicator lamp in the charging
station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact Husqvarna customer
service.
Light Cause
Solid green light
Good signals
Green flashing
The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Yellow flashing
The guide wire is not connected to the
light
charging station.
Break in the guide wire.
Red flashing light
Interruption in the charging station's an-
tenna.
Solid red light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
982 - 001 - 12.12.2018
Action
No action required
ECO mode is
No action required. For more informa-
ECO mode . Refer to ECO mode
tion on
on page 24 .
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Refer to
wire on page 18 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler.
Check that the guide wire connector is
properly connected to the charging sta-
tion. Refer to
on page 18
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Contact Husqvarna customer service.
Contact Husqvarna customer service.
To install the guide
To install the guide wire
Troubleshooting - 39