Operation; The On/Off Button; To Start The Product; Operating Modes - Husqvarna 115H Operator's Manual

4.1 The ON/OFF button

WARNING: Read the safety
instructions carefully before you start
the product.
WARNING: Keep your hands and feet
away from the rotating blades. Never
put your hands or feet close to or
under the machine when the motor is
running.
WARNING: Do not use the product
when persons, especially children, or
animals, are in the work area.
• Press the ON/OFF button to turn the product
on. The product is active when the indicator
lamp on the ON/OFF button is lit.
• Press the ON/OFF button to turn the product
off.
4.1.1 The indicator lamp
The indicator lamp on the ON/OFF button is an
important status indicator:
• The product is active if the indicator lamp
lights continuously.
• The product is in standby if the indicator
lamp flashes. This means that the operator
must press the ON/OFF button to make the
product active again.
• The product is disabled when the indicator
lamp is not lit.

26 - Operation

4 Operation
WARNING: It is only safe to carry out
inspection or maintenance on the
product when the product is disabled.
The product is disabled when the lamp
on the ON/OFF button is not lit.

4.2 To start the product

1. Open the hatch to the keypad.
2. Push the ON/OFF button. The display is lit
up.
3. Use the up/down arrow buttons and the
OK button to enter the PIN code.
4. Select the desired operating mode and
OK OK confirm with the OK button. Refer to
Operating modes on page 26 .
5. Close the hatch.
Note: If the product is parked in the charging
station, the product will only leave the charging
station when the battery is fully charged and if the
schedule allows the product to operate.

4.3 Operating modes

When the Mode button is pressed the following
operating modes can be selected:
• Main area
• Secondary area (2nd area)
• Park
• Park / Schedule
• Override schedule
• Spot cutting
OK
982 - 001 - 12.12.2018