Husqvarna 115H Operator's Manual page 37

Message Cause
Today's mowing
The rest period is in progress. The
completed
product has an inbuilt standby period
according to the Standby time table.
Lifted
The lift sensor has been activated as
the product has become trapped.
Collision sensor
Product body can not move freely
problem, front/rear around its chassis.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left
around the drive wheel.
Safety function
Temporary electronic or software rela-
faulty
ted issue in the product.
Electronic problem
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
Temporary battery
Temporary battery or software related
problem
issue in the product.
Battery problem
Charging current Wrong or faulty power supply unit.
too high
Connectivity prob-
Potential problem on the connectivity
lem
circuit board in the product.
Connectivity set-
The connectivity settings was restored
tings restored
due to a fault.
982 - 001 - 12.12.2018
Action
This behavior is normal and no action
is required.
Free the product.
Check that the product body can move
freely around its chassis.
If the problem remains, the message
requires action by authorized service
technician.
Clean the wheels and around the
wheels.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
Disconnect and reconnect the battery.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Please check and change the settings
if needed.
Troubleshooting - 37