Fault Messages - Husqvarna 115H Operator's Manual

6.2 Fault messages

Below a number of fault messages are listed which may be shown in the display of the product.
Contact Husqvarna customer service if the same message appears often.
Message Cause
Wheel motor
Grass or other object has wrapped
blocked, left around the drive wheel.
Wheel motor
Grass or other object has wrapped
blocked, right
around the drive wheel.
Cutting system
Grass or other object has wrapped
blocked
around the blade disc.
The blade disc lies in a pool of water.
No loop signal
The power supply is not connected.
The low voltage cable is damaged or
not connected.
The boundary wire is not connected to
the charging station.
Boundary wire broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
The boundary wire is crossed on its
way to and from an island.
The connection between the product
and the charging station has been bro-
ken.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
34 - Troubleshooting
Action
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Check the wall socket connection and
whether an earth-fault breaker has trip-
ped or not. Check that the low voltage
cable is connected to the charging sta-
tion.
Check that the low voltage cable is not
damaged. Check that it is also properly
connected to the charging station and
to the power supply.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
To install the boundary
aged. Refer to
wire on page 18 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
Find breaks in the
nal coupler. Refer to
loop wire on page 41 .
Place the product in the charging sta-
tion and press the STOP button. Refer
ECO mode on page 24 .
to
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
install the boundary wire on page 18 .
Place the product in the charging sta-
tion and generate a new loop signal.
Try moving the boundary wire.
982 - 001 - 12.12.2018
To