Find Breaks In The Loop Wire - Husqvarna 115H Operator's Manual

Symptoms Cause
Both the mowing The battery is spent.
and charging times
are shorter than
usual.
The product is The product has an inbuilt standby peri-
parked for hours in od according to the Standby time table.
the charging sta- Refer to
21 .
tion.
The STOP button has been activated.
Uneven mowing The product works too few hours per
results. day.
The shape of the work area requires
the use of
find its way to all remote areas.
The
relation to the layout of the work area.
Work area too large.
Dull blades.
Long grass in relation to the set cutting
height.
Accumulation of grass by the blade
disc or around the motor shaft.

6.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such
as when gardening with a shovel. In countries
with ground frost, also sharp stones that move in
the ground can damage the wire. Breaks can
also occur due to the wire being stretched
excessively during installation.
Mowing the grass too low right after the
installation can damage wire insulation. Damage
to the insulation may not cause disruptions until
several weeks or months later. To avoid this,
982 - 001 - 12.12.2018
To set the schedule on page
Area 1-3 for the product to
How often? setting is incorrect in
Action
Replace the battery. Refer to
on page 31 .
No action.
Open the hatch, enter the PIN code
and confirm with the OK button. Press
the Start button and then close the
hatch.
Increase the mowing time. Refer to
calculate the schedule setting on page
21 .
Area 1-3 to steer the product to a
Use
remote area. Refer to
Coverage function on page 22 .
Check that the correct
ue is selected.
Try limiting the work area or extending
the work time. Refer to
schedule on page 21 .
Replace all the blades. Refer to
place the blades on page 30 .
Increase the cutting height and then
successively lower it.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
Clean the product on
jects. Refer to
page 29 .
always select the maximum cutting height the
first weeks after installation and then lower the
height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead
to disruptions several weeks after the splice was
done. A faulty splice can, for example, be the
result of the original coupler not being pressed
together hard enough with a pair of pliers, or that
a coupler of lower quality than the original
coupler has been used. Please first check all
known splices before further troubleshooting is
done.
Battery
To
To set the Lawn
How often? val-
To set the
To re-
Troubleshooting - 41