Battery - Husqvarna 115H Operator's Manual

5.5 Battery

WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery. In the event of leakage of
electrolyte flush with water and seek
medical help if it comes in contact with
the eyes etc.
WARNING: Use only original batteries
recommended by the manufacturer.
Product safety cannot be guaranteed
with other batteries. Do not use non-
rechargeable batteries.
CAUTION: The battery must be
charged fully before winter storage. If
the battery is not fully charged it can
be damaged and in certain cases be
rendered useless.
If the operating times for the product are shorter
than normal between charges, this indicates that
the battery is getting old and eventually needs
replacing. The battery is fine as long as the
product maintains a well-cut lawn.
Note: Battery life is dependent on the length of
the season and how many hours a day the
product is operating. A long season or many
hours of use a day means that the battery must
be replaced more regularly.
5.5.1 To replace the battery
WARNING: Use only original batteries
recommended by the manufacturer.
Product safety cannot be guaranteed
with other batteries. Do not use non-
rechargeable batteries. The appliance
must be disconnected from the supply
mains when removing the battery.
1. Press the ON/OFF button for 3 seconds to
turn off the product. Check that the indicator
lamp on the ON/OFF button is not lit.
982 - 001 - 12.12.2018
2. Set the cutting height to MIN (2).
3. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the display cover.
4. Clean around the battery cover.
5. Unscrew the screws to the battery cover
(Torx 20) and remove the battery cover.
6. Release the latch of the connector and pull it
upwards.
CAUTION: Do not pull the cables.
7. Release the latch of the battery holder and
lift up the battery holder (including the
battery) from the product. If the new battery
is encapsulated in a hard plastic shell, go to
number 10.
8
7
8. Release the latch of the battery and lift up
the battery from the battery holder.
9. Place the new battery into the battery
holder.
Note: The sticker "This side down" must be
facing up when you place it into position.
This means that "This side down" will be
facing downwards when the product is
standing on its wheels.
7
6
Maintenance - 31