Web Setup - Dataprobe iBoot-PoE General Description Manual

Web power switch for power over ethernet
Hide thumbs Also See for iBoot-PoE:
Table of Contents

Advertisement

iBoot-PoE setup section consists of several pages. Access any page via the buttons on the left of the
page. Each time a setting is changed click on the Save button for that page to save the changes before
moving to the next page. To return to the control page, use the Status / Control button.
5.1. Device Settings
Location ID: Set a 20 Character name to be
displayed on the top of the Home page.
assists in identifying which iBoot-PoE is being
accessed.
Cycle Time: 1 to 999 seconds power cycle time.
This is the length of time the power will be off
during a reboot, or on during a power burst.
Initial State: The outlet can be set to the state it will assume when the iBoot-PoE is powered up or reset
The choices are: On, Off and Last, meaning the state it was in when the power was removed or reset
commenced.
Upgrade Enable: Check this box to allow remote firmware upgrades of the iBoot-PoE. When this box is
unchecked, firmware upgrades will not be allowed.
Auto Logout: This setting sets the automatic logout for inactivity on both the web and telnet users. It can
be set from 0 to 99 minutes. 0 disables the Auto Logout feature.
As the iBoot-PoE allows only one Web user logged in at any time, use caution when disabling the
timeout feature, as it is possible to lock out other users by forgetting to logout. Closing the
browser will not log the user out and will lock out web access.
access the iBoot-PoE via Telnet and reboot the unit, or press the reset button.
5.2. Network Settings
IP Mode: Select Static to set the IP address using
the fields below, or DHCP to allow a DHCP server
to set the IP Address.
IP address: Enter a static IP address. This will be
automatically set if using DHCP
Subnet Mask: Enter the Subnet Mask. This will be
automatically set if using DHCP
Gateway: Enter the Gateway. This will be automatically set if using DHCP
DNS: Enter the Domain Name Server address. This will be automatically set if using DHCP.
iboot-poe_v180808n

5. Web Setup

This
iBoot-PoE
If you do become locked out,
.
Page 13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iBoot-PoE and is the answer not in the manual?

Table of Contents