Dataprobe iBoot-PoE General Description Manual page 22

set cycle <1-999>
get cycle
set upgrade enable <yes | no>
get upgrade enable
login
logout
reboot
Network Commands
get network
set ipmode <static | dhcp>
set ipaddress <dotted decimal>
set subnet <dotted decimal>
set gateway <dotted decimal>
set http port <0-65535>
set telnet port <0-65535>
set dxp port <0-65535>
iboot-poe_v180808n
This command is used to set the cycle time, in seconds
This command returns the current cycle time
Enables or disables the ability to upload new firmware to the iBoot-PoE.
This command displays the upload enable status.
Prompts for admin credentials when logged in as user
Terminates the session
This command reboots the iBoot-PoE.
All set commands require a reboot before they take effect. These commands are only available to the
administrator.
This command will return all the network settings as shown below:
Mode: DHCP
IP Address: 192.168.1.254
Subnet: 255.255.255.0
Gateway: 192.168.1.1
DNS: 8.8.8.8
HTTP Port: 80
Linkback URL:
Telnet Port: 23
DxP Port: 9100
Timeout: 20
This command sets the ip address setting mode. Static mode locks the address as
set, dhcp mode allows DHCP server to assign address.
This command is used to set the iBoot-PoE's ip address.
This command is used to set the iBoot-PoE's subnet mask.
This command is used to set the Gateway
This command sets the port that the iBoot-PoE's web server listens for incoming
connections on. When set to 0 the web server is disabled.
This command sets the port that the iBoot-PoE's Telnet server listens for incoming
connections on. When set to 0 the Telnet server is disabled
This command sets the port that the iBoot-PoE's DxP protocol service listens for
incoming connections on. When set to 0 the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The CLI will protect against all 3
from being set to 0.
iBoot-PoE
10
No
DHCP
192.168.1.254
255.255.255.0
192.168.1.1
80
23
9100
Page 22