Dataprobe iBoot-PoE General Description Manual page 23

set linkback <url>
set timeout <0-99>
Automation Commands
get autoping
set autoping <1 | 2> address <dotted decimal or
name>
set autoping <1 | 2> frequency <1-999>
iboot-poe_v180808n
This command sets the linkback URL displayed on the logout page.
This command sets the automatic network timeout in minutes
0 = Timeout not used.
These commands require a reboot before they will take effect. These commands are available
to the administrator only.
This command returns all of the AutoPing settings as shown below.
AutoPing 1
Address: 192.168.233.254
Frequency: 10
Fail Count: 3
Status: OK
Trig Count: 0
-------------------------------
Mode: Single
Action: Cycle Once
Wait: 2
Restart: 0
This command is used to set the address of AutoPing 1 or AutoPing 2. Use IP
Address or domain name.
This command is used to set the frequency (how often the iBoot-PoE sends the
ping) for each of the AutoPings.
iBoot-PoE
AutoPing 2
iboot.co
10
3
OK
0
Page 23
2
10