Table of Contents
Advertisement
set autoconfig start
get autoconfig
User Commands
set user account <yes | no>
set login required <yes | no>
set password <user | admin> <old> <new> <repeat>
Event Commands
get events
set time enable <yes | no>
set time server <dotted decimal>
get time
set event <1-8> <run | hold>
iboot-poe_v180808n
Starts auto config
Displays the status: Running or
Found: No device, Single Ended, Multi Ended
These commands are only available to the administrator.
This command sets whether or not a user account is used.
administrator account is active
This command sets whether or not a login is required for user level operation. A
login is always required for admin functions.
This command is used to set the password of either the user or administrator.
These commands are only available to the administrator.
This command displays all scheduled events as shown below. Example:
Date
Time
Repeats
1. 01/13/2013 16:00 every
2. 01/13/2013 16:15 every
3. 01/15/2013 17:00 every
4. 02/16/2014 12:00 every
5. 02/16/2014 12:10 every
6. 02/17/2013 01:05 every
7. 02/18/2013 01:00 every
8. 03/18/2014 01:00 every
This command enables or disables the use of the time server and scheduled
events.
Note: When Adding new events through the CLI. Set this to no to prevent
unintended power switching
This command is used to set the IP Address of a network time server.
Displays the current time and time server settings:
Current Time: 07/30/2015
Timezone:
-5
DST:
Enabled
Starts the 2nd Sunday of March at 2:00
Stops the 1st Sunday of November at 2:00
Server:
time.nist.gov
This command is used to all the event to run, or put the event on hold
iBoot-PoE
Action
1 Day(s)
On
Run
0 Day(s)
On
Run
1 Hour(s)
Cycle
Run
1 Day(s)
Off
Run
1 Day(s)
On
Run
0 Day(s)
On
Run
0 Day(s)
On
Run
0 Day(s)
On
Run
10:41:05
Page 25
If <n> only the
n
y
user
admin
No
69.90.182.55
run
Advertisement
Table of Contents
Need help?
Do you have a question about the iBoot-PoE and is the answer not in the manual?
Questions and answers