Inventory - Grizzly POLAR BEAR SERIES Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory (Figures 8–9)
A. Edge Sander w/Main Table Assembly ....... 1
B. 4" Dust Port ................................................ 1
C. Miter Gauge ................................................ 1
D. End Table Assembly ................................... 1
E. Legs ............................................................ 4
F. Upper End Supports ................................... 2
G. Lower End Supports ................................... 2
H. Upper Side Supports .................................. 2
I.
Lower Side Supports .................................. 2
J.
Carriage Bolts M8-1.25 x 12 ..................... 32
K. Flat Washers 8mm ................................... 36
L. Hex Nuts M8-1.25 ..................................... 32
M. Hex Bolts M8-1.25 x 20 .............................. 4
N. Lock Nuts M8-1.25 ..................................... 4
O. Fender Washers 6mm ................................ 9
P.
Lock Washers 6mm.................................... 4
Q. Hex Nuts M6-1 ........................................... 4
R. Hex Bolts M6-1 x 20 ................................... 4
S. Carriage Bolt M6-1 x 15 ............................ 1
T.
Knob M6-1 ................................................. 1
U. Phillips Head Screws M5-.8 x 15 ................ 2
V.
External Tooth Washers 5mm .................... 2
W. Hex Nuts M5-.8. ......................................... 2
X. Rubber Feet. .............................................. 4
Model G0839P (Mfd. Since 04/18)
A
B
Figure 8. Inventory—edge sander and
E
Qty
G
J
K
L
Figure 10. Inventory—hardware.
C
components.
F
H
Figure 9. Inventory—stand.
M
N
O
P
Q
R
D
I
S
T
U
V
W
X
-15-