Controls & Components - Grizzly POLAR BEAR SERIES Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
A
Figure 1. Controls and components (side).
A. ON/OFF Switch w/Disabling Key: Turns
motor ON and OFF. Remove yellow key to
disable switch.
B. Back Stop: Supports workpiece during
edge-, end-, and face-sanding operations.
C. Miter Gauge: Supports workpiece for angle-
sanding operations.
D. Main Table: Used for edge/end sanding
operations. Raises or lowers to allow sanding
against full width of sanding belt to maximize
usability of each belt. Table also tilts for bevel
sanding.
-4-
manual BEFORE
B C D
E
Figure 2. Controls and components (front).
E. Main Table Height Lock Knobs: Tighten to
secure main table height position; loosen to
adjust main table height.
F. Main Table Height Handle: Use to raise
and lower main table up and down.
G. Main Table Tilt Lock Knobs: Tighten to
secure main table angle; loosen to adjust
main table angle.
H. Main Table Angle Pointer: Shows angle of
main table tilt.
I. End Table Tilt Lock Knob: Tighten to
secure end table angle; loosen to adjust end
table angle.
Model G0839P (Mfd. Since 04/18)
I
F
H
G