Adjusting Table Height & Tilt - Grizzly POLAR BEAR SERIES Owner's Manual

Adjusting Table
Height & Tilt
adjusting table height tilt
The height of the main table is adjustable. You
adjust the table height according to the thick-
ness of your workpiece. If you repeatedly sand
workpieces of similar size, adjust the table height
periodically to ensure the sanding belt wears
evenly.
Both the main and end tables tilt from 0°–45°.
Tilt the main table to sand workpieces with
bevelled edges and ends. Tilt the end table to
sand workpieces with bevelled contours.
Adjusting Main Table Height
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen main table height lock knobs (see
Figure 30).
Main Table Height
Lock Knobs
Main Table
Height Handle
Figure 30. Main table height lock knobs and
handle location.
3. Raise or lower main table, using main table
height handle as leverage (see Figure 30).
4. Tighten main table height lock knobs while
holding main table in place.
-26-
Adjusting Main Table Tilt
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen main table tilt lock knobs (see
Figure 31).
3.
Manually adjust main table angle, using scale
pointer as guide (see Figure 31).
Main Table Tilt
Lock Knobs
Figure 31. Main table tilt lock knobs and scale
pointer location.
4. Tighten main table tilt knobs while holding
main table in place.
Adjusting End Table Tilt
1. DISCONNECT MACHINE FROM POWER!
2. Loosen end table tilt lock knob (see
Figure 32).
3. Manually adjust end table angle, using scale
pointer as guide (see Figure 32).
Tilt Lock
Lock Knob
Figure 32. End table tilt lock knob and scale
pointer location.
4.
Tighten end table tilt knob while holding end
table in place.
Model G0839P (Mfd. Since 04/18)
Scale
Pointer
Scale
Pointer