Grizzly POLAR BEAR SERIES Owner's Manual page 21

6. Insert (4) M6-1 x 20 hex bolts in holes through
upper end supports and upper side supports
(see Figure 16).
Note: This step ensures holes through upper
end supports and upper side supports remain
aligned during fastener tightening in Step 7.
Figure 16. Hex nuts inserted in holes through
upper end supports and upper side supports.
7. Fully tighten all fasteners, and then remove
(4) M6-1 x 20 hex bolts inserted in Step 6.
Risk of lifting injury! Edge
sander/table
weighs approximately 170
lbs. Get lifting help from
two additional people or
use power lifting equip-
ment such as a forklift.
8. With help from another person, place edge
sander on top of stand (see Figure 17).
Figure 17. Edge sander placed on stand.
Model G0839P (Mfd. Since 04/18)
9.
10. Attach ON/OFF switch box to edge sander
ON/OFF
Switch Box
assembly
Figure 19. ON/OFF switch box attached to edge
Edge
Sander
Stand
Secure edge sander to stand with (4) M6-1
x 20 hex bolts, (8) 6mm fender washers,
(4) 6mm lock washers, and (4) M6-1 hex nuts
(see Figure 18).
x 4
Figure 18. Edge sander secured to stand.
with (2) M5-.8 x 15 Phillips head screws, (2)
5mm external tooth washers, and (2) M5-.8
hex nuts (see Figure 19).
Edge Sander
sander.
Edge Sander
Stand
x 2
-19-