Grizzly POLAR BEAR SERIES Owner's Manual page 7

L
J K
N
Figure 3. Controls and components (rear).
J. End Table: Used for contour-sanding opera-
tions. Table also tilts for bevel sanding.
K. Belt-Tracking Control Knob: Adjusts align-
ment (tracking) of sanding belt (refer to
Page 25 for more information).
L. Belt Tensioning Lever: Releases belt ten-
sion when removing/replacing sanding belt.
M. Belt Cover Knob: Use to engage/disengage
belt cover latch.
N. End Table Scale Pointer: Shows angle of
end table tilt.
O. Platen Lock Handle : Secures platen assem-
bly in vertical position for edge and end sand-
ing, and in horizontal position for face sand-
ing and sanding belt removal/replacement.
Model G0839P (Mfd. Since 04/18)
M
O
Like all machinery there is potential danger
when operating this machine. Accidents
are frequently caused by lack of familiarity
or failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, seri-
ous personal injury may occur.
No list of safety guidelines can be com-
plete. Every shop environment is different.
Always consider safety first, as it applies
to your individual working conditions. Use
this and other machinery with caution and
respect. Failure to do so could result in
serious personal injury, damage to equip-
ment, or poor work results.
-5-