Table of Contents
Advertisement
CERTIFIBER™
4.2.2 S
AVING AN
To save the results of an Autotest, take these
steps:
1. Highlight Fiber 1 on the RX side or Fiber
2 on the TX side and press F1 (Save) to
name and store the measured values with
a time stamp.
2. The Job Name screen will be displayed.
3. Highlight a Job name and press F1
(Select).
The performed Autotest
will now be saved under
the selected Job Name.
If you do not want to use
CertiFiber's Job Name
feature, highlight the first
item on the list (Not
Used), and press F1
(Select).
4. If the Job Name you wish
to use was not predefined
in the Job Name setup
screen, CertiFiber allows
you to edit one by
pressing F2 (Edit).
5. The Save Circuit ID
screen will be displayed
with an arrow in the
titlebar indicating which
fiber the test result is for.
The overall Test Result is
located right below the
arrow.
42
A
UTOTEST
Advertisement
Table of Contents
