Display Contrast - Black Box CertiFiber TS655A Manual

CERTIFIBER™
3. Select a fiber standard. TIA-568-A and
ISO 11801 are the most widely used fiber
standards.
4. Press the Autotest button.
5. Enter the number of splices and
connectors.
6. Press F1 (Run). CertiFiber will now run
the length, propagation delay, and dual
fiber-loss measurements for 850 nm and
1300 nm and provide a PASS/FAIL
analysis based on the chosen fiber
standard.
7. Press F1 (Save) to name and store the test
result for each fiber.
8. Press F2 (View) to display test results and
move between fibers.
9 Put the covers back on the
ST connectors on the CertiFiber and
CertiFiber Remote.
Test results can now be viewed in the Results
screen. To print test results, they need to be
uploaded to a PC using the included
ScanLink
®

2.10 Display Contrast

CertiFiber's display contrast can be adjusted.
From the logo screen, press Shift + up-arrow
or down-arrow to increase or decrease the
contrast.
22
software. Refer to
Section 4.2.3
.